The new chemical composition of primobase substantially reduces the stickiness commonly known with this type of materials and greatly increases the curing and fitting properties. More info...
only 1.2 mm thick and extremely precise
-
primobasesame strength as conventional double the thickness impression tray materials -
primobaseonly 1.2mm thick, so hardly any need to adjust and/or shorten denture teeth to match the given vertical dimension during the set-up -
primobaseextremely precise – to an extent that the base plate with the set-up teeth “adheres” to the palate during the try-in (suction effect) -
primobasedoes not require a second curing cycle off the model upside down -
primobasecures in most conventional light curing units (do not use strobe lights!)
-
primobasesame strength as conventional double the thickness impression tray materials
-
primobaseonly 1.2mm thick, so hardly any need to adjust and/or shorten denture teeth to match the given vertical dimension during the set-up
-
primobaseextremely precise – to an extent that the base plate with the set-up teeth “adheres” to the palate during the try-in (suction effect)
-
primobasedoes not require a second curing cycle off the model upside down
-
primobasecures in most conventional light curing units (do not use strobe lights!)
uses
· full and partial denture bite registration
· denture set up and try in
· temporary partials (flippers)
advantages
· only 1.2 mm thick, so hardly any need to adjust and/or shorten denture teeth to match the given vertical dimension during the set-up
· same strength as conventional double the thickness impression tray materials
· extremely precise – to an extent that the base plate with the set-up teeth “adheres” to the palate during the try-in (suction effect)
· does not require a second curing cycle off the model upside down
· cures in most conventional light curing units (do not use strobe lights!)
product pictures
· full and partial denture bite registration
· denture set up and try in
· temporary partials (flippers)
· only 1.2 mm thick, so hardly any need to adjust and/or shorten denture teeth to match the given vertical dimension during the set-up
· same strength as conventional double the thickness impression tray materials
· extremely precise – to an extent that the base plate with the set-up teeth “adheres” to the palate during the try-in (suction effect)
· does not require a second curing cycle off the model upside down
· cures in most conventional light curing units (do not use strobe lights!)
technical tipsuseful tips for your workflow
- Use a bit of Metatouch (IM200) finger and instrument separator on your fingertips to smoothen the primobase surface after adaptation.
- For the most precise fit use the Metavac vacuum suction device. This will ensure that the base plate is fully pressed against the model during the light curing process.
working procedurethe workflows for standard applications
working procedure:
- Apply separator to the model (preferably Metatouch IM200)
- Adapt the base plate to the model with your fingers and/or instrument
- For an even more precise fit use the Metavac suction device (TZ-KIT). This will ensure maximum precision
- Cure for 6 minutes – no second curing cycle off the model needed
- Remove base plate and finish it
- Use a bit of Metatouch (IM200) finger and instrument separator on your fingertips to smoothen the primobase surface after adaptation.
- For the most precise fit use the Metavac vacuum suction device. This will ensure that the base plate is fully pressed against the model during the light curing process.
working procedure:
- Apply separator to the model (preferably Metatouch IM200)
- Adapt the base plate to the model with your fingers and/or instrument
- For an even more precise fit use the Metavac suction device (TZ-KIT). This will ensure maximum precision
- Cure for 6 minutes – no second curing cycle off the model needed
- Remove base plate and finish it
baseplates